Car Relay Tester Universal 12V Electronic Automotive Relay Tester Car Battery Checker

CNBJ-707 is a quick go/no-go tester relays that provides with indication of the general health and functioning of the most common Automotive relays. Tester will check for proper functioning of the relay contacts by connecting the car battery (11V--15V) to the relay coil. Tester will watch the pin configuration,the time to contacts closure and opening, consistency of the relay during each test session, Tester will light the GREEN LED if all passed during the test session,if not light the RED LED.

Why Do You Need a Car Relay Tester

Made of high qualified material, it is solid and durable.
Keep you informed of the condition of your car relay.
By continuous automobile battery(11V-15V) to the relay coil.
Check the relay contact function properly.
Watch the pin configuration, the time to contacts closure and opening, consistency of the relay.

Automotive relays test tool.
The tester observes contact data, closure time, relay inertia at each test stage, etc.
Test to properly control the opening and closing of the relay.
If the relay is abnormal the red LED will light, it's normal the green LED will light.
Fine workmanship and good performance.
Easy to operate.
Convenient to carry.
Durable in use.

The Steps are as Follows

1. Connect the power leads to the car battery --black alligator clip to negative terminal, red alligator clip to positive terminal.
2. Tester is powered up when the LED illuminates in RED.
3. Check the relay before plugging into the tester. If it's a 4 pin relay,select"4 pin" on the tester.If it's a 5 pin relay, select"5 pin"on the tester.
4. Plug in the relay into one of the three receptacles.
5. Press the "TEST" button.
6. Tester will check the pin configuration of the unknown relay. Tester will light the RED LED if the unkonwn relay is not the same to the most of common automotive relaysor the pin of the unknown relay is destroyed.
7.Tester will open and close the relay 10 times for testing the time to contacts closure and opening if the pin configuration of the relay is right. Tester will light the RED LED immediately if the time is overtime.
8. Tester will check the consistency of the relay after testing the time to contacts closure and opening ten times. Tester will light the GREEN LED if the test passed, if not light the RED LED.
9. Disconnect power leads from the car battery and remove relay from the tester.

Actual Scene Application

4 pin and 5 pin switch, the TEST button starts the test.

Attention

1. The car battery must be 12V battery, and the voltage of the battery is among 11V-15V.
2. Ideal for coil resistance above 20 ohms.

Product Details

Products Show

Product Packaging

1 x 12V Relay Tester