2021 Newest AdBlue Emulator EURO 6 Truck Adblue Emulator For Vol-vo for BEN/Z Support Euro6 adblue Emulator for Man/DA-F/IVE-CO

Adblueobd2 Emulator for MAN Euro6

EURO6 AdBlue Emulators Disable System:

– AdxBlue system (Fully)

– AdxBlue NOX sensor

– DPF system

– DPF temperature sensors

– DPF regeneration

After installing Euro6 Emulator, you can remove:

– DPF sensors – YES

– NOx sensor – YES (only in DAF don’t remove first NOx sensor !!!)

– Adblue temp. sensor (s) – YES

– Adblue pump – YES

– Adblue level sensor – YES

– Adblue ECU – YES

Kindly
note: It is possible to disable AdxBlue system by installing an AdxBlue
emulator (programmable device) into the vehicle. You can switch it
on/off anytime.

EURO6 AdBlue Emulators using guide:

Emulator
Man Euro 6 does not need to be learned. You install emulator under the
metal cover of AdBlue Pump on the right side behind the cab, and
disconnect plug from AdBlue Pump and connect emulator.

Next, you need to remove the fuses:

F894(Multisensor In AdBlue tank)

F738 (+30 Signal of AdBlue pump)

F1084 (NOx sensor Upstream)

Fuse F737 is now fuse of emulator.

Fuse
F1109 is the fuse of NOx sensor Downstream and A1191 mufler temperature
sensor. This sensor needs to work correctly for DPF regeneration.

Finally
you need to remove Power from NOx downstream sensor. There are two ways
options, one is to cut pin 1 in NOx sensor plug, the other way (better)
is to remove pin 10 in X3212 plug. This plug is visible on rear of
engine on the right side. This is TE plug (16 pin) with yellow key.