2PCS Aluminum Left Right Fender Shrouds Kit Black/Red Panel Plate Engine Bay w/ Hardware For 2008-2014 Subaru WRX & STI YX02429
Application:

For 08-14 Subaru WRX /STi.

Vehicle compatibility charts are for REFERENCE ONLY. Check product type and size to match your needs.

Specification:

100% quality assurance tested, more responsive, less expensive, easier to install.

Change the look of the engine bay for a sleek and clean new look.

Angled cutouts,pulley cover design conceal the factory fender gap.

Extend the full length of the fender from headlight to firewall.

Powder-coated a nice wrinkle finish to be corrosive resistant.

Precision mounting holes to fit perfectly under your hood.

No factory plastic fasteners are reused, eliminating under hood rattles.

Material & Color:

Material: made of high quality Aluminum.

Color: as picture.

Package Included:

1x Left Fender Shroud;

1x Right Fender Shroud;

W/ Accessories.(100% Brand New Never Used Or Installed)

Installation Steps:

1.With hood closed, take note of gap between fender and hood. Due to loosening of fender bolts, this gap could change after installation. This can be adjusted during the last step if fender does not line up as desired.

2. Open hood and locate and remove six M6 bolts holding both left and right fender to chassis.

a. These fasteners are factory painted and will crack slightly as they are loosened.

b. Your fender may be under some tension and move when these are loosened.

Note: some adjustment may be necessary during the last step of final tightening of hardware.

3. Install supplied plastic spacers on both fenders as shown, making sure that two spacers get installed over the front most holes.

4.Set fender shrouds over spacers and align with holes in chassis. Starting with rear most hole, install supplied washer and bolt through shroud, and through spacer into the chassis. Work your way up to the front bolt where the shroud will need to be pressed down slightly to get bolt started.

5. With bolts started, move fender shroud to desired position and tighten bolts.

Note: Make sure that bolts pass through the center of each spacer during this step.

Note: If fender moved during step 1, you may have to move fender back while tightening bolts. After this is done, check that fender lines up with hood as it did before step 1.

6. Check hardware for tightness after a week of driving to ensure they have not loosened.

Note:

Provide Tracking Number With Every Order, Please Buy With Confidence!

No installation guides are included, we highly recommend to seek professional installation. Any damage during installation will not be refunded.

Will come with everything you see in the picture. Please allow difference due to manual measurement.

Please check that the picture matches before purchase. The color of the actual items may slightly different from the listing images due to different computer screen, thanks for your understanding.

For any inquiries or special requests such as larger amount ordering please write to us.

Communication is the best way to solve the problem. If you have any problems after purchasing, please contact us in time, before opening return or case.