Dimensions :

- 85mm diameter (3-3/8’’)
- 55mm Depth (2-3/4’’)

Features :

- GPS SOG: Speed Over Ground: 0-600km/h
- ODO: odometer: 0-999999km
- TRIP: 0-999.9km
(can be adjusted by the back button.)
(Return Zero When off electricity)
- COG: Course Over Ground

Specification:

➽ Fuel Level: 0-100%
(Press the back button to adjust the
level signal: 0-190Ω/240-33Ω available.)

➽Water Temperature: 40-120℃/100-250℉
(Temperature sensor: 301-22ohm)
※ the water temperature is displayed by default.
If you need oil temperature,
please contact us to customize.

➽ Oil Pressure: 0-10 bar/0-145psi
(Pressure sensor: 10-184ohm)
(After power on, press the back button to adjust unit, if the oil pressure unit is "psi", the temperature unit will be "℉".)

➽Voltmeter: 9-32V

➽ Total Engine Hours: 0.0-99999.9H
(Press the back button to adjust.)

➽Tachometer: 0-9999RPM
Speed Ratio: 1.0-360.0; Step Value: 0.1

Package Included

- 1*6 in1 Multifunction Gauge
- 1*Multi-plug socket
- 1*GPS Antenna
- 1*Instruction

Function:

1.the degree of protection is IP67.

2. With TFT Screen, can display the range clearly

3.Sensor Fault Alarm(Chinese and English can be switched)

Connection

1.Black : Ground(-)
2.Red : 9-30VDC
3.Blue : RPM Signal
4.Yellow : Temperature Signal
5.White : Oil Pressure Signal
6.Fuel Level Signal

Setting:

1.After power on, touch the button, we can switch the unit: km/h, mph, knots, and save automatically.

2.Keep on pressing the rubber button of the backside for 3 seconds, and then enter into setting mode, if leave button
More than 3 seconds, it will be out of setting mode. The value will increase when you press the button. When you leave the button and then press it again, the value will decrease. The minimum step value is 0.1 and the adjustable range Is 1~360.When you get the required speed ratio value after adjustment, please leave the button. The tachometers will auto save your setup after 3 seconds. If the setup doesn't meet your demand, please re-setup.

3. Press the button first, then power on, and then enter the parameter selection mode, press the button once to select the
0-190ohm (European) level sensor or 240-33ohm (American) level sensor,

press the button twice to select the temperature unit and pressure unit. (℉ and Psi ) or( ℃ and Bar) and the meter save automatically.

4, Quick touch the button for 5 times, and then enter the engine hours setting mode, when you press the button the
Engine hours will increase, when you leave the button and then press it again, the engine hours will decrease, when you get the required value after adjustment, please leave the button, and the meter will auto save your setup after 3 seconds.


5. Then quick touch the button for 5 times again, and then enter into the OD0 setting mode, when you press the button
the OD0 will increase, when you leave the button and then press it again, the ODO will decrease, when you get the required value after adjustment, please leave the button, and the meter will auto save your setup after 3 seconds.