Specifications:

-Fixing dimension: 85mm(3-3/8")
-Working Voltage: 12V/24V
-Total Mileage Adjustable, Mileage Range: 0-999999 km
-GPS Blind Area Odometer Compensation
-OverSpeed Buzzer Alarm (Value Adjustable)
-Indication light: LEFT, HIGH BEAM, RIGHT
-Backlight: Red and Yellow available
-Working temperatures: - 40 to 85°C
-Operation mode: LCD display, stepper motor

Features:

-Suitable for all vehicles and off-road vehicles

-The signal comes directly from the satellite signal receiver(GPS Antenna), don't need other speed sensor.

-The gauge has the advantages of high precision, quick location confirmation and short start up time.

-IP67 waterproof and dustproof grade

-Reverse polarity protection and anti-fogging performance

-No Stationery Drift

-Stepper motors used for full range of stepping gauges, great feature with its less power consumption, longer life, higher precision, etc.

Package include:

1x GPS speedometer
1x GPS Antenna
1x Multi-plug socket
1x Installation Instruction

Installation Guide:

1. Cut an 85mm (3 3/8") hole in the panel (II) allow a clearance of . behind the panel.
2. Remove fastening ring (I), insert gauge from front. Tighten gauge (III) using fastening ring ( I)
3. Connect cables according to the diagram. Choose red or yellow background light.
4. Securely fasten the GPS antenna, preferably outdoors (or inside front windscreen) so that it
has a clear view of the sky to pick up satellite signals. Connect the antenna cable to socket on the
gauge. Do not cut cable.
5. After turning power on, allow the gauge to sample satellite signal for 1 minute.
6. All data is for reference only and should not be trusted as sole navigation source.

Function Select： “ODO” , “BUZZ”

Press and hold on the button at the back, then turn on the power supply.
The LCD will show ODO, BUZZ, etc.
You can select the function to be set after release button.

1.“ODO”(change total odometer)

After selecting “ODO”, the LCD will show for example “5000” (5000 km) ,
press the button tochange the flashing digit from 0 to 99999 to set the target odometer value.

2.“BUZZ”

After selecting “BUZZ”, the LCD will show for example “B 80” (buzzer will be on when speed over
80km/h), press the button to change the flashing digit from 10 to 240 to set target overspeed
buzzer alarm threshold value.

Please noted:

After setting, you should disconnect both Power+ and GND, and then reconnect
the two cable, then it will save the setting. If you just cut Power +, then it’ll not work properly