Ancel PB100 Circuit Tester 12/24V Power Probe Circuit Test Automotive Car Voltage Diagnostic Tools

PB100 Description :

the PB100 power scan kit is the most revolutionary circuit tester to date, featuring AVOmeter, test light , built -in flashlight , short circuit indicator , relay/component tester , continuity tester and bad groud indicator , the power scan is truly the ultimate in power and affordablity , allowing users to check circuitry in one single step . an absolute must for every technician looking for a fast and accurate solution to electrical systems diagnostics.

Top Reasons to Chose Ancel PB100 Power Probe Circuit Tester

1. Extremely easy to use and highly reliable

2. Built-in Flashlight enables you to work in the dark

3. Easy to read AVOmeter allows you to read voltage, current and resistance at the fingertip

4. With 6 Meter long electronic cable, convenient to test around the car

5. Test mode contain AV Voltage, DC Voltage, Current Resistance, LED, including most car circuit test system

6. Including Cigarette Lighter adaptor, battery test clips, easy to get supply in the car

PB100 Electrical System Circuit Tester Features:

1: Perform power injection, measuring, ground testing, polarity checking, continuity testing and component activation.

2: Find short to ground and short to voltage.

3: Automatically detect the positive, negative and open circuit.

4: Three additional modes: MIN / MAX / Audible Monitoring.

5: AC-RMS, AC Peak to Peak, Frequency and Pulse Width for signal testing.

6: High Voltage Capability: display up to 60 Volts, Resolution of 0.1 Volt.

7: 8 Amp Circuit Breaker Protection, automatically Reset, No Button to Push.

8: Comes with 20 foot Power lead and extra 20FT extension cable.

9: 2 power source: Vehicle battery and cigarette lighter.

10: Larger brighter color LCD display and easy menu navigation.

11: Ergonomic housing design with water resistant rugged blow molded case, easy to handle and store.

12. Read the AVO meter, voltage, current, and resistance easily.

13. Press the power switch lightly and get the instant heat ground lead to energize the electrical components, such as the cooling fan, relay etc.

14. Activate the components by using the hot wire and ground lead simultaneously.

15. Determine the positive, negative and open circuit quickly.

16. Test the bad ground contacts quickly, follow and locate short circuits without wasting the fuse.

17. Test the continuity of the power switch, relay and diode quickly.

18. Protect the tool from overload through the inner circuit breaker.

19. Bulit-in flashlight enables you to work in the dark.

20. Circuit breaker protected.

1. Work Mode

There are four modes to diagnose the electrical systems,which can be accessed by depressing the Mode Button and cycling through each one.

2.Voltage and polarity testing

Easy to Determine the Positive, Negative and Open Circuit

3. Circuit Continuity Testing in Resistance mode

While the tool is in Resistance mode,using the probe tip with chass is ground or the auxiliary ground lead,continuity can be tested on wires and components attached or disconnected from the vehicle's electrical system.When the probe tip is contacting a good ground,the LCD will indicate"0.0Ω" and green LED wiil be on,A beep tone will sound.

4.Activaring components in your hand

5.Activating components in the vehicle

6.Testing Trailer Lights and connections

AC Cricuit signal testing

For example,you suspect there is a problem with your M.A.P.?sensor circuit,then follow the procedure involved with testing this sensor:

Set the tool in AC Voltage mode,using the probe tip with chassis ground or the auxiliary ground lead.

Connect vacuum pump to MAP sensor.

Contact the probe tip to the MAP sensor positive terminal and observe the LCD readings which should be a sine wave in normal condition.

Apply vacuum

Release vacuum and observe the LCD reading

7.Activating components W/Ground

Product detail

Package contain