Auto Car Circuit Test Repair Tool Set, Sensor Signal Simulator Cable With Diode Test Light 1.5m Wire

Specification:

Diode test light
Blue and white. Banana head and connecting line should be corresponding. Diode test light is red to positive pole, black to negative lancet to insert injector, and light flashes indicating that the signal is normal test light. If there is phenomenon of constant light or no light, the injector signal is incorrect.

Potentiometer
Positive and negative poles and signal lines. This product is mainly to simulate sensor signal to observe changes in the data stream to determine quality of the line. At the same time, it is also possible to simulate signal of the temperature sensor and test post-treatment of urea.

Barbed wire
The voltage can be measured. Hook wire is hooked by the hook of remaining ripper. Handle is pierced, and multimeter is connected by a connecting wire to complete the measurement of the wire.

Cable
1.5 meters long. Red line is positive pole, black is negative. There is a power take-off port which is convenient to insert test light to test signal is normal, connect the twister to the multimeter.

Safety pin
5A, 10A, 15A, 25A insurance films, total 37pcs. Don't be afraid of car glitch, all kinds of safety tablets are prepared.

Common resistance
2KΩ 1/2W 20 common resistors.