Applications: 42RLE Automatic Transmission: (KJ) For Jeep Liberty
(2006-2007) , (KK) For Jeep Liberty (2008-Newer) , (KA) For Dodge Nitro
(2007-Newer)

Applications: 62TE Automatic Transmission: (JS) For Chrysler Sebring /
For Dodge Avenger (2007-Newer) , (RT) For Chrysler Town & Country /
For Dodge Grand Caravan (2007-Newer)

Applications: CVT Automatic Transmission: (MK) For Jeep Compass / For
Jeep Patriot (2007-Newer) , (PM) For Dodge Caliber (2007-Newer)

Applications: NAGI Automatic Transmission: (LC) For Dodge Challenger
(2008-Newer) , (LX) For Chrysler 300C / For Dodge Charger / For Dodge
Magnum (2005-Newer) , (WK) For Jeep Grand Cherokee (2005-Newer)

Installation Instruction:
1. Verify that the vehicle is parked on a level surface.
2. Remove the dipstick tube cap.

***WARNING:***
1.There is a risk of accident from vehicle starting off by itself when engine running.
There is a risk of injury from contusions and burns if you insert your
hands into the engine when it is started or when it is running.
Secure vehicle to prevent it from moving off by itself.
Wear properly fastened and close-fitting work clothes. Do not touch hot or rotating parts.
3. Actuate the service brake. Start engine and let it run at idle speed in selector lever position "P"
4. Shift through the transmission modes several times with the vehicle stationary and the engine idling
5. Warm up the transmission, wait at least 2 minutes and check the oil
level with the engine running. Push the oil dipstick into the
transmission fill tube until tip contacts the oil pan and pull out
again, read off oil level, repeat if necessary.
***NOTE: The dipstick protrudes from the fill tube when installed.
6. Check transmission oil temperature using the appropriate scan tool.
***NOTE: The true transmission oil temperature can only be read by a scan tool in Reverse or any forward gear position.
7. The transmission oil dipstick has indicator marks every 10mm.
Determine Height of the oil level on the dipstick and using the height,
the transmission temperature, and the Transmission Fluid Level Graph,
determine if the transmission oil level is correct.
8. Add or remove oil as necessary and recheck the oil level.
9. Once the oil level is correct, install the dipstick tube cap back into the tube.