Color	Blue Red white
Blue Red white
Spec.	10.6X9cm 11.7X10cm

Description
Customer Reviews(0)

Item specifics

Sticker Placement Car Light
Origin Mainland China
Model Vehicle Logo
Item Length 10.6cminch
Design Words
Item Width 9cminch
Model Name For Nissan LED Emblem
Item Height 0cminch
Category Emblems
Item Type Stickers
Packaging Not Packaged
is_customized Yes
Item Diameter 0cminch
Type Other 3D Sticker
Material Type Abs
Type Of Sticker Other

Product Description

Please measure and compre your emblem`s size before purchase
Fit for Nissan TIIDA X-TRAIL Geniss LIVINA Cedric
Size:10.6X9cm/11.7X10cm(about)
Wiring length:A:0.25M(about)
Quantity:1 piece
Material:ABS
Installation location:car /rear
Need to know:
1.If you need other car logos,please contact us.
2.Please measure and compre your emblem`s size before purchase

Tools prepared before installation:
Please prepare the following tools: 1. Flat screwdriver 2. Cross screwdriver 3. Insulating tape 4. Towel 5. Pliers

Installation instructions:
1. Please measure and compre your emblem`s size before purchase.Lay a towel next to the trunk logo (to prevent scratching the body), and use a flat screwdriver to pry the logo
2. Peel off the double-sided adhesive tape of the old logo from the car body, gently pry off the logo, and clean up the residual double-sided adhesive tape.
3. Use a cross screwdriver to remove the partition board inside the boot, pay attention to the buckle, and carefully remove the sound insulation board.
4. Install the logo light. The power line of the logo light passes through one of the logo positioning holes and goes into the trunk. Tear off the single-sided adhesive on the back of the car sign lamp, stick the car sign lamp to the body while pulling the cable, and press it tightly.
5.Power Connection:Rear Emblem is connected to the license plate light`s power.
6. Unplug the plug, peel a hole at the positive and negative poles, expose the wire core, connect the wire according to red to red and black to black, and don't forget to wrap it with insulating tape, and finally plug the plug back! Replace the boot lid insulator.