Rearview Mirror Adhesive

Car Rearview Mirror Profressional Strength Adhesive Kit Glue Car DIY Repair Accessories Strength Bonding For Glass & Metal

Activator: Net.0.020FL OZ(0.6ml)
Adhesive: Net.0.014FL OZ(0.4ml）

Excellent Bonding For Glass&Metal
Cure Within 15 Minutes

Easy To Use

-Apply activator
-Apply adhesive

Use For Metal Buttons Only

-Non-removable permanent bonding
-No-drip activator
-No plastic

Important

READ INSTRUCTIONS CAREFULLY BEFORE MOUNTING MIRROR
·lf button is mounted incorrectly, DO NOT ATTEMPT TO REMOVE Bond another button over the original one.
·Repair at temperatures between 50℉ and 75℉ (10℃ to 24℃)
·DO NOT use on plastic buttons.

Cures in 15 minutes

The required strength is reached after 15 minutes at room temperature and fully cured, requiring 12 hours.

How To Use

1. Remove mounting button from mirror bracket Make note which side faces upwards.
2. On outside of windshield, circle wth a crayon to identify old location of mirror button.
3. Thoroughly scrape windshield glass and button to remove all old adhesive. All old adhesive must be removed in order for new appli ation to adhere.
4. Open Cleaner/Activator Towelette by pulling both sides of protective packet at the point at top of package. Fold packet back to use. Towelette is to remain attached to packet.
5. On inside of windshield, clean marked area and prime with Cleaner/Activator Towelette . Allow to dry for 20 second. DO NOT TOUCH windshield after the activator has been applied. Note：Do not wipe the button with the Cleaner-Activator Towelette.
6. Remove twist off cap then cut off adhesive tip. Apply one drop of
adhesive to the center of button only. NOTE：DO NOT apply adhesive to both button and glass as adhesive will not work properly.
7. IMMEDIATELY apply the button to the windshield, ensuring that the correct side is facing up, and hold firmly in place for 1 minute. Allow to set for 30 minutes prior to mounting mirror.