Product selling points:

1. The propeller draws the airflow into the combustion chamber at a higher speed, thereby generating atomized combustion, thereby increasing horsepower and saving gasoline.

2. Gravity mold aluminum alloy material design, stainless and durable, rubber bracket can increase the diameter of the fan to install in the pipe.

3. The dual-throttle fan rotates with the speed of the engine, and at the same time generates the greatest force, generating a powerful airflow into the combustion chamber at high speed.

4. The single-sided turbine is installed on the intake hose of the engine. When the engine starts normally, the inertial pulling force of the engine's natural air intake is used to drive the space wheel to rotate at a high speed.

5. While rotating, it drives a lot of fresh air into the engine continuously. At the same time, the forced air generates a vortex, which mixes the high-speed rotating air with the fuel sprayed by the injector, which greatly increases the air density in the intake hose. The energy with a certain mixing efficiency is greatly increased, and greater explosive power will be generated during combustion. , Actually increased the power.

Install:

Remove the intake hose between the air purifiers.

Put the intake fan into the intake hose.

Use the attached rubber bracket to install into a larger diameter pipe.

Specifications:

Product Name: Turbo Compressor

Color: red/blue/silver/black

Material: aluminum alloy, rubber

Features: durable, fuel-efficient, and improve fuel efficiency

Dimensions (diameter x L): about 2.5 x 2.95 inches / 6.4 x 7.5 cm

Installation location: 10CM before the throttle

Installation Notes:

Installed in the intake hose between the bellows of the original car and the throttle. When installing, it depends on the diameter of the original car's intake hose and the thickness of the rubber ring of the power wheel itself. Each rubber collar has a different thickness, which should be appropriately selected according to the diameter of the intake hose during installation.

Applicable vehicle size (for reference only): suitable for Toyota 56-65mm (800cc~2000cc), suitable for Mazda 71mm (more than 2000cc), suitable for Ford 56-71mm (800cc~more than 2000cc), suitable for Honda 71mm (more than 2000cc) For Mitsubishi 71mm (more than 2000cc), it is suitable for Nissan 65mm (1300cc~2000cc) (There are three caliber silicone sleeves (height are 55mm) to choose from: 1.55mm, 2.65mm, 3.71mm, here are 3 double-sided matching.

Product list: turbo compressor +3*rubber sleeve