[xlmodel]-[custom]-[44609]

[xlmodel]-[custom]-[8888]

How to buy what you need Car Horn?

Dear friend,We have three sales specifications for this link, please purchase according to your needs

[xlmodel]-[photo]-[0000]

[xlmodel]-[custom]-[8888]

If you want to hear the sound ,Please enter below link.

http://youtu.be/iIRkbHJ8hFc

Why we need a Harness?

*More convenient

If your car have only one horn,but you want to modify to two horns.It is necessary to use this horn relay harness

**More secure         

If to use this horn harness,your car's controller power will be only 1.6W.Then your original car wire that is more secure.

***More Loud

If to use this horn harness,it just like to install a parallel circuits.It will make your "old" horn become "younger".The sound will be much louder than before.

****Warning 

1.If you buy a new car,it is no need to buy this harness.Because it is not "Magic harness".It follows the science.It can only help "old" car become "younger".

2.If your car drive for a long time,we do not suggest u to purchase a new high current(loudness) horn.Because it will increase your car wire's pressure.It is unsafety.PLEASE BE CAREFUL.   

1.The real test in our laboraroy that show to us the horn can get 130db.  

2.Super long surround sound,it make the sound powerful and comfortable so that decrease the traffic accident.  

(CHSKY, Let your family keep away from potential rist.)  

3.We used the imported high quality manganese steel to make the soundboad so that can make the fullest possible "BABA~~" sound.  

4.We use the most advanced Teflon coat technology.I can be dust-proof and water-proof effectively(We must inform you that there are not have any horn factory can make a universal horn that all waterproof).It prolong the lifetime of the horn effectively.  

5.We used the 100%ABS material to make the horn bulb.It has very good Heat resistance,impact resistance,anti-corrosion so that can prevent the dinas and the heat of the engine damage for the horn.Anyway,it also has high hardness characteristic.It can drop from 1 meter that is not easy to break.  

a. Snail down or 45 degree Angle installation, Prevent water  into coiled directly  

b. If you are not special peason , don't change the angle degree of Steel Support,or it will change the Original air gap.  

c. Mounting torque of Steel support is between 6Nm to 11Nm.  

d. The horn support should be mounted to Solid surface to avoid resonance.  

e. In order to avoid contact with other parts of the car,The horn should be connected with horn support and installed to wide and Ventilated place.  

f. Nonpolarity requirements for this product, the connected place of the wire should solid enough, Double horn should installed on solid part of car body in parallel way.  

g. Keep away from car motor and much Radiation place. Not be too low mounting.  

h. Don't keep the horn on for 60 seconds, or it will lead to the coil burned down.  

i. Using copper wire, more than 1.5mm for wire Diameter, the wire length should less than 4m.  

j. Standard mounting Voltage, input working current more than 30A,12V horn voltage: 9-14.5V    

[xlmodel]-[custom]-[8888]

[xlmodel]-[custom]-[43704]

We maintain high standards of excellence and strive for 100% customer satisfaction! Feedback is very important We request that you contact us immediately BEFORE you give us neutral or negative feedback, so that we can satisfactorily address your concerns.

It is impossible to address issues if we do not know about them!