** Important notice: The EL glow gauge is emitted by AC voltage, the inverter will transform the 12VDC to 50~75 VAC. After connecting to power, don't touch bare terminals or solder points over the output side, will cause uncomfortabel electric shock. The natural color of EL (electro-luminescent ) is between blue and green, we design the inverter with high and low frequencies, the high frequency will emit the EL to glow blue color, and the low frequency will emit EL to glow green color. A switch on the dimmer allows you to change frequency /color. However a disadvantage of the design for blue glowing will cause high frequency noise. There is no solution to remove the noise but can minimize the noise by decreasing the brightness or switching to green light section. If the glow gauge is white light, the high frequency will emit cold white, and low frequency emits warmer white light. Before purchasing this item, please consider this fact.

Fitment:

for W124 W126 W201(190E) 1985 1995 (240km max speed, No economy gauge)

Product information: 

1. Package inlcudes 1 set EL glow gauge  and 1 piece inverter
   

2. This gauge is with speedometer in KMH (Km/hr)
   

3. Black face. Reverse glow type. White light.
   

4. Brightness adjustable thru the controller on the inverter. 
   

5. May be necessary to remove needles for installation, please operate gentlely to avoid damage the needles.
   

6. Anti-glare and scratch resistance surface. 
   

Product Pictures: 

If you cannot find an item for your car, please check below pictures and tell us the composition you need. 

Installation Guide: 

1. Disconnect the negative terminal on the battery.
   

2. Remove screws that hold the bezel and cluster. 
   

3. 
   

   Disconnect the wire plugs to the cluster.

4. Remove the clear cover that protects the needles and the black housing around the gauge.
   

5. If there are screws that hold the faceplate remove them.
   

6. Gently slide the gauge face over the needle.  For those needle holes smaller than needle hub, please gently remove the needle. 
   

7. Locate a spot to run wire in the cluster.
   

8. Screw in the screws to the faceplate, if removed.
   

9. Install back the clear protection cover.
   

10. Plug the connectors of faceplates to inverter.
    

11. Locate the controller to desire place.
    

12. ground the black wire, and positive red wire to parking light. 
    

13. Connect the negative terminal on the battery.
    

Duty and Tax

Please be informed, you will be responsible for below additional costs happen at the destination. 

These are not included in the shipping fee we collect, and must be paid by receipient when the goods have arrived but before delivery. 

1. Customs Duties 

2. Import VAT

3. Other customs-related surcharges

4. Handling Fee (may be requested by some of the carriers)

For detail information, you may contact with your customs office. Thank you.