Note:

The product has a version with a mounting bracket and a version without a mounting bracket. Please choose the product that suits you according to your actual situation. Please note that for product beauty, products with mounting brackets do not have the word 'Gear' on the top of the surface.

Features:

Condition:100% Brand New
Light Color: Red/Blue/Green
1-6 Level IP68 Waterproof Gear display

Fitment:

For Husqvarna 701 Enduro ALL YEARS
For Husqvarna 701 Supermoto ALL YEARS
For Husqvarna Vitpilen 701 ALL YEARS
For Husqvarna Svartpilen 701 ALL YEARS

Installation:

You need to connect 4 wires to the bike’s wiring harness. Good quality quick connectors are supplied (4 pcs wire taps). No need to cut any wires and no need for soldering.
All connections can be done either under the fuel tank, at the ECU box or behind the instrument cluster.

The table below shows the connection overview:

To complete the install, it is recommended that you consult with your dealer and/or refer to the Service Manual available for your bike.
Due to the large number of bike models and vehicles compatible with this Kit, model specific wire colors and install instructions are not described in this document.

Setup:

You need to setup the module after installation. When ignition is turned on, the
display counts backwards (6 to 1) indicating that the memory is clear.
- Raise the rear wheel off the ground by using a stand, and start the
engine in Neutral. (If you do not have a stand, you may setup the unit while
riding. Find a long, straight road with light traffic.)
- The display will blink “1”.
Select first gear, release the clutch, and keep the RPM above idle speed.
The display is blinking faster while the unit is learning the gear.
- When the display shows “2”, select second gear.
Repeat this process until all gears are thought (5 or 6).
The unit is programmed and should indicate the gears correctly.
Now, when ignition is turned on, the display counts forward (1 to 6) indicating
that it is fully functional.