Item specifics
-
Brand Name
GFYSHIP
-
Origin
CN(Origin)
-
Item Weight
0.28kg
-
Special Features
Not Plug Play
-
Item Width
0inch
-
Model Name
For Suzuki With EFI Engine
-
External Testing Certification
ce
-
Item Diameter
0cm
-
Item Height
0inch
-
Item Length
0inch
-
Material Type
As the picture shown
-
Item Type
Motorcycle LCD Electronics 6 Speed 1-6 Level Gear Indicator
-
Display Range
1-6 Gear Display
-
Waterproof Level
IP68
-
Connector Type
Need to connect two connectors and a wire
-
Special Function
No need to cut any wires and no need for soldering
-
Installation Notes
With installation instructions
-
Application 01
For Suzuki GSF600 Bandit
-
Year 01
2000 2001 2002 2003 2004
-
Application 02
For Suzuki GSF650 Bandit
-
Year 02
2005-2006
-
Application 03
For Suzuki GSF1200 Bandit
-
Year 03
2001-2006
 Features: Condition:100% Brand New
Light Color: Red/Blue/Green
1-6 Level IP68 Waterproof Gear display Fitment: For Suzuki GSF600 Bandit 2000-2004
For Suzuki GSF650 Bandit 2005-2006
For Suzuki GSF1200 Bandit 2001-2006 Locate the Speed Sensor connector: The Speed Sensor is usually mounted on the front sprocket cover, and the 3-pole black speed sensor coupler is situated 20-40 cm (8”-16”) away from sensor.
The connector is accessible by raising the fuel tank, removing the seat or a side fairing. Confirmation: 1. Separate the Speed Sensor connector (you might need to use a small flathead screwdriver to get the connector apart). Rotate the rear wheel while ignition is on. The speedometer should indicate 0. If so, turn the ignition off and proceed to the next step. Otherwise, if the speedometer registers a speed other than 0, you have not disconnected the correct coupler and need to look again.
2. After separating the Speed Sensor connector, plug in both the male and female 3-pole GFYSHIP harness connectors. Make sure the connectors are fully seated.
3. Find the wire that comes from the Signal generator (Pickup coil / CKP sensor).
If in doubt, check the bike’s Service Manual or ask your dealer.
4. Connect the GFY Black/Green wire to this wire, using the Red wire tap connector supplied. Setup: You need to setup the module after installation. When ignition is turned on, the display counts backwards (6 to 1) indicating that the memory is clear.
- Raise the rear wheel off the ground by using a stand, and start the engine in Neutral. (If you do not have a stand, you may setup the unit while
riding. Find a long, straight road with light traffic.)
- The display will blink “1”.
Select first gear, release the clutch, and keep the RPM above idle speed.
The display is blinking faster while the unit is learning the gear.
- When the display shows “2”, select second gear.
Repeat this process until all gears are thought (5 or 6).
The unit is programmed and should indicate the gears correctly.
Now, when ignition is turned on, the display counts forward (1 to 6) indicating
that it is fully functional.
| 
eBike Accessories
Motorcycle Parts