Intelligent Pulse Repair Battery Charger 

Parameters:

1. Input Voltage: 110-250V

2. Output voltage: 12V/24V

3. Current:15A peak for 12V,18A peak for 24V

4. Suitable capacity: 30-200AH

5. Power:600W

6. Frequency: 50-60HZ

7. Length of output wire:65cm

8. Length of input wire:125cm

9.  Dimension: 68*34*49cm

10. Gross weight:2 kg

11. Application: best suitable for30-200AH lead acid batteries(including wet and dry)

 Multiple protections  

Overheat protection: The charger will close automatically without current output for protective purpose when its temperature is over 105℃, and when the temperature is decreased below about 80℃ or power supply is shut down for 10 minutes, charging process can be resumed.

Short circuit protection: In case of accidental short circuit, the charger will close automatically without current output, and beep for alarming. Once correctly connected, charging process will be resumed.

Reverse connection protection: Whenever positive poles and negative poles of the charger and the battery are not connected correctly, the charger will close automatically without current output, and beep for alarming. Once correctly connected, charging process will be resumed.

Low voltage protection: When single cell voltage is below 1.5V, the charger can not be started up, and beep for alarming. This mechanism is to avoid possible damages caused up by voltage discrepancy between the battery and the charger.

Five-stage charging mode

What this charger can be used for  ?

     As show in the picture

Charging operation    

    Step 1, Examine and make sure rated voltage of battery is conforming to output voltage of charger.

Step 2, Connect correctly the charger and the battery.

Step 3, Examine and make sure mains supply voltage is conforming to input voltage of the charger.

    Step 4, Connect mains supply and the battery, watch to see if the indicator is on and the cooling fan is working when charging.

Step 5, if the charger refuse to work, turn off mains supply immediately and check all the connecting cables between mains supply, the battery and the charger.