Car Battery Charger

1.Applicable to the 12V/24V lead acid battery. 2.Advanced pulse width modulation (PWM) technology. 3.Five Charging Modes: No-load Mode/Constant Current Mode/Constant Voltage Mode/Float Mode/Trickle Mode. 4.The battery life can be significantly improved by digital pulse repairing method for the power chips of microcomputers. Package Included: 1 X Car Battery Charger 1 X User Manual For 12V/24V, 6-200AH Lead Acid Battery or Lithium Battery of motorcycles, van, sport utility vehicle etc.

For 12V/24V,6-200AH Lead Acid Battery or Lithium Battery of motorcycles,van sport utility vehicle etc.

We have two versions of different language choices. English Version andRussian Version.

English Version

Russian Version

This item can be used both 110V/220V of input AC power.

VI. Charging operation 

    Step 1, Examine and make sure rated voltage of battery is conforming to output voltage of charger.

    Step 2, Connect correctly the charger and the battery.

    Step 3, Examine and make sure mains supply voltage is conforming to input voltage of the charger.

    Step 4, Connect mains supply and the battery, watch to see if the indicator is on and the cooling fan is working when     charging.

    Step 5, if the charger refuse to work, turn off mains supply immediately and check all the connecting cables between mains supply, the battery and the charger.

For vehicle batteries, motorcycle batteries (small volume) which have been laid unused for a long time, the charging indicator may not go ON when charging (due to small current requirement resulted out of large internal resistance).In this situation, you can charge at the same time of huge power discharging (consumption).By this means you can judge if the charger is defective, and at the time the charging indicator will flash.(Normally, you can continue to floating charge for approximately 1 hour after the charging indicator turns Off until the fully charged. At this time, the battery is in excellent condition, you can use freely) (Though the indicator does not flash, the charger is in fact charging the battery in trickle floating mode. And, once large current need from the battery is detected by the charger, the indicator will go flashing).

SPECIAL NOTICE:

1. Charging batteries of leakage for the first time shall be under manual monitoring. To avoid overcharging and bubbling,   for the 1st and 2nd time, charging shall be stopped immediately once temperature rise is found of the battery. Temperature rise indicates that the battery is full before being charged or there is leakage which does not influence its usage.

2. When the charger is charging the battery, the cooling fan shall be working regularly.

3. An adjustable charger can adjust current size in accordance with battery needs for a better battery protection. For example, if the current is 30A before charging, you are advised to decrease to 25A. Similarly, if 25A, you are advised to decrease to 20A. The 20% spacing shall better protect your battery as well as your charger.

    If the battery is not needed urgently, you are advised to charge by 1/10, i.e. 10AH battery to 1A charging current.