Car Rearview Mirror Adhesive

Feature:
1. Product material: The rearview mirror glue is composed of two parts: the mirror glue and the activator;
2. Product Features: It is superior to epoxy glue and 502 products, and has good high temperature and moisture resistance;
3. Wide range of uses: Rearview mirror glue is mainly used for the bonding of rearview mirrors and windshields. Can also be used to bond and connect metal to metal, glass and glass, glass to metal, ceramics, jewelry;

packing list:
1* car rearview mirror adhesive

How to use it

1. Remove mounting button from mirror bracket Make note which side faces upwards.
2. On outside of windshield, circle wth a crayon to identify old location of mirror button.
3. Thoroughly scrape windshield glass and button to remove all old adhesive. All old adhesive must be removed in order for new appli ation to adhere.
4. Open Cleaner/Activator Towelette by pulling both sides of protective packet at the point at top of package. Fold packet back to use. Towelette is to remain attached to packet.
5. On inside of windshield, clean marked area and prime with Cleaner/Activator Towelette . Allow to dry for 20 second. DO NOT TOUCH windshield after the activator has been applied. Note：Do not wipe the button with the Cleaner-Activator Towelette.
6. Remove twist off cap then cut off adhesive tip. Apply one drop of
adhesive to the center of button only. NOTE：DO NOT apply adhesive to both button and glass as adhesive will not work properly.
7. IMMEDIATELY apply the button to the windshield, ensuring that the correct side is facing up, and hold firmly in place for 1 minute. Allow to set for 30 minutes prior to mounting mirror.

Product Note:

A. Q: Can this glue only be used to bond the rearview mirror?
A: Although this rubber is developed for rearview mirror bonding, it can be used to bond metal and glass, metal and metal, glass and glass materials.

B: Q: It will fall off quickly after bonding?
A: The biggest problem is that the residual glue is not removed. The essence of the glue is cured in an anaerobic environment. The residual glue causes the base to be completely sealed from the glass, and the anaerobic conditions are not achieved, and the curing strength is affected.

C: Q: Why wait for the curing agent to bond in a semi-dry state? How to judge to reach half dry?
Answer: The solvent is added to the curing agent to dilute the concentration of the active ingredient. In the use, the solvent needs to be volatilized. In the semi-dry state, the solvent is volatilized, and the active ingredient remains on the surface. Semi-dry can be observed through the eyes, the surface of the "watermark" volatilized, the time is generally 15 seconds.

D: Q: curing time
A: The effect of the temperature of the mirror glue on the curing time